F329 S>max V>max Flex Guide TM P>max GAS SPRING WITH EXTERNAL THREAD 013 .00250. 250 200 100 150 50 50 60 70 80 90 100 110 120 130 140 150 5 10 25 0 50 100 75 1,00 1,05 1,10 1,15 1,20 1,25 1,30 1,35 1,40 100 080 063 050 038 025 force daN charge pressure (bar) stroke in mm pressure rise factor nominal stroke Initial spring force versus charge pressure Spring force Diagram displacement versus stroke rise Pressure rise factor accounts for displacement but not external in…uences! Note: Initial spring force at 150 bar = 250 daN Order No for spare parts kit: 2480.12.00250 Pressure medium: Nitrogen N2 Max. filling pressure: 150 bar Min. filling pressure: 50 bar Working temperature: 0°C to +80°C Temperature related force increase: ± 0.3%/°C Max. recommended extensions per minute: approx. 80 to 100 (at 20°C) Max. piston speed: 1.6 m/s Fixing: Installation with ring nut(s) 2480.005.00250 can be done with one or two ring nuts. If the hole in the bolster plate is not threaded, two ring nuts are needed. Holes threaded M 38 × 1,5 require one only ring nut for mounting of the gas springs. Mounting with a threaded flange plate has the advantage of a degree of adjustability as far as the flange screws permit, moreover it is often found easier to make do with a clearance hole in the tool plate. Locking is by way of two lock screws with thrust plugs, provided in the threaded flange. Diameter of through-hole in tool plate = 38 mm – plus four tapped holes M 8. 6 ø15 14 1 ±0,25 l min. l 2480.32.00250. M38 x 1,5 Strokemax. M6 valve 2480.32.00250. Gas spring with external thread Order No Strokemax. (s) lmin. l 2480.32.00250.013 12.7 62.7 75.4 2480.32.00250.025 25 75 100 2480.32.00250.038 38.1 88.1 126.2 2480.32.00250.050 50 100 150 2480.32.00250.063 63.5 113.5 177 2480.32.00250.080 80 130 210 2480.32.00250.100 100 150 250
RkJQdWJsaXNoZXIy MTIwNzY0